Corrections: Copper fills - It is usually better to put the GND fill on the rear and Vdd on the front, as the majority of traces will be on the front slicing up that fill, but connections to GND are more common so that is the more important plane.

Hard to understand how this video didn't get more views and upvotes; it's super helpful. I love all your content; thanks so much for sharing!

This is one of the best follow along instructionals of any category here on YouTube. I am very impressed with this presentation. Great job!

Press 'V' while routing to place a via on the net. Press 'U' after selecting a segment of a trace to select all segments of the trace.

"mils" and "thou" are also used most often in machining.

The GOAT 🐐

Very good work!!

Great video. In some case I would have rotated the dip 180 degrees to make left near left.

You make fabulous videos. I guess you need a lot of practice to get this correct. Cheers

Just here to say I am heavily judging you for that right angled trace from R1 to SW1.